work

Today I was supposed to go to work with Brian and Jordie from Keswick at 8:30 or so. I ended up waiting for Bri till almost 11:30. We went over to the shop and got to cracking on all sorts of projects. but we mostly focused on finishing the mechanics area. We finally got home at around 6:30 or so. Jess and I watched the end of Rudy and then went out to eat at the Oregon Dinner, and picked up some stuff at Target.

If the electricians and the construction guys at the shop can get their act together we will open for the 1st. I just hope we could do it.
I promised some pictures of the new Keswick shop in Cherry Hill, NJ. It is no where near done, but here you go.
This is a view looking towards the back of the shop. There will be 2 dressing rooms on the right side as well as the mechanics area. The left side (where you see the platform) will be the Serotta fit area.
This is also a view towards the back. It shows the counter where there will be two registers. The area under the courigated steel is the upstairs mechanics area. There will be two mechanics in there most of the time.

This is a view towards the front of the shop. The road out front is Route 70E through NJ. Both sides of the yellow walls will be covered with bike racks two high and a few deep along the walls. The big boxes in the middle of the floor are all of the hard wood that is going on the floor. Some of it was laid while I was there today, and it looks really good.
This is a picture of part of the basement looking from the back towards the front. There are about a hundred built bikes already down there. There is tons of space down there. This will be storage for the shop, and a long term repair area. It is great to have so much room to move around.